Neto's latest activity

N

Neto replied to the thread Please help me with my new pool build and equipment.

I agree to avoid pebble over plaster if you want the surface to feel soft. I recommend pmm marquis marbletite, that is what I have on...

Jan 16, 2021
N

Neto replied to the thread Plumbing leak help.

whatever you get, make sure it is SCH 40 PVC

Jan 1, 2021
N

Neto replied to the thread What is this plug and is it necessary.

looks like a temp probe but the cord is broken?

Dec 23, 2020
N

Neto replied to the thread Heater Install on exisiting pool.

How many gallons? Typical installations are 400k btu.. Also, how close is the propane tank and what is its size? When I lived in...

Dec 22, 2020
N

Neto replied to the thread Coping Tile Lifting Up.

looking at your pictures, if you remove too much of the existing mortar it could damage the waterline tile.. Try using a chisel and get...

Dec 22, 2020
N

Neto replied to the thread What is going on here? How did this happen?.

If these travertine pavers were installed over concrete then most likely that looks like mortar, not grout. You have to use an angle...

Dec 22, 2020
N

Neto replied to the thread 2 years later, I am finished!.

thats an incredible build! I also did my pool but shotcrete and plaster, however it was nothing like that!

Dec 21, 2020
N

Neto replied to the thread single 2"suction line presure limits.

Thanks for the suggestions, do you mind explaining why the weak link is the filter? I thought I bought the top of the line cartridge...

Dec 18, 2020
N

Neto reacted to HermanTX's post in the thread single 2"suction line presure limits with Like.

From what I have read in other posts for 2" PVC - is 63gpm which maintains flow under the velocity of 6ft/sec guideline (for suction)...

Dec 18, 2020
N

Neto posted the thread single 2"suction line presure limits in Pumps, Filters, and Plumbing.

so i have a 10k gallon pool that has an attached elevated spa. It has 3 main drains (2" individual pipes) and one skimmer line (2") for...

Dec 17, 2020
N

Neto replied to the thread WiFi master temp 125.

i did, i am still waiting for it.. Its true, sounds too good to be true but its worth the risk IMO since its Amazon

Dec 15, 2020
N

Neto replied to the thread WiFi master temp 125.

x2 for the intelliconnect, its $100 on amzn

Dec 14, 2020
N

Neto replied to the thread PB says Intelliflo VSF is maxed out at 75 gpm. Need some guidance.

my vsf is also maxed out at 100 gpm and that is increasing the max pressure to 35psi

Dec 14, 2020
N

Neto replied to the thread SWG max flow without producing chlorine.

how about those spa jets 🤣.

Dec 9, 2020
N

Neto replied to the thread SWG max flow without producing chlorine.

Yes, I do have a 3 way valve for that one

Dec 9, 2020

Show older items

Top Bottom