Recent content by meatty

There are a total of 14 logged alarms. Mostly low flow, one low ambient temperature and the very first one was no RS-485 connected, so this is likely going back to when I installed the system. Given that appear to have been more than 30 restarts in the last 7 minutes of operation, it sounds...

I assume the RS-485 is required to handle cooling. Am I mistaken there?

saw the same pattern today (despite ambient in the 70s): The alert screen on screenlogic shows nothing - going to go check the heatpump panel now (and then I'll flip to local control to see if it heats up, unless something comes very clear.

I will try this - thanks.

Any particular pictures more helpful?

Yes QUOTE="JamesW, post: 1741880, member: 18171"] What is the solar temperature reading? Where would I find this? Given that it is not being used as solar, I don't think this is presented anywhere (it's not immediately obvious on the outdoor unit, the app or on screenlogic): Yes, I said...

Yes, it's before (and that one registers about 2 degrees cooler, which now makes sense to me). Here's a picture of the system. Also, note that the solar temperature sensor just dangles beside the air temp sensor, because (in the spade connection note on page 14 of the manual) it says it just...