mas985's latest activity
-
mas985 replied to the thread Pump size and number of jets..Does each loop have equal number of jets and are the jets the same size? Also, make sure the PB installs a Hartford loop on each of the... -
mas985 reacted to Packfan's post in the thread My Aqua Logic (AQL-PS-8) keeps going into Service Mode when running Aux 3 Edge Pump with
Like.
The local keypad is what goes into "Service Mode". I could take it off and perhaps spray some electronic contact cleaner on it. Though... -
mas985 replied to the thread Pump size and number of jets..You need to go by GPM not HP. If you are set on 12 jets, I would go with two plumbing loops with a VS pump and 6 jets on each loop...
-
mas985 replied to the thread Dolphin gear is slipping.Those are plastic hydraulic bearings so they are designed to wear like that and eventually have to be replaced. No different than the...
-
mas985 replied to the thread No flow and no pressure on filter.Looks like the screw head really got chewed up. Something else may have failed as well. Is the diffuser and volute still in good condition?
-
mas985 replied to the thread Urgent - please critique my design. Dig tenatively scheduled in 1.5 weeks.With 2x5' sheers you will need at least two pumps if you want to run the sheers and anything else at the same time. Recommendations for...
-
-
-
mas985 reacted to cwscott's post in the thread Recommended Salt Levels for Salt water Pools with Like.
i like this thought process and it makes sense to me.
-
mas985 replied to the thread No flow and no pressure on filter.Yes, it means that the impeller has dislodged from the motor shaft. As to fixing it, it most likely is the impeller that broke and yes...
-
Unless you have unique circumstances, you don't need a dedicated pump for your water features. My setup is almost the same as yours and...
-
mas985 replied to the thread No flow and no pressure on filter.That water level is fine. If the drive is still alarming, then the issue is likely with either the impeller broke off or something is...
-
mas985 replied to the thread Dedicated Spa Jets Pump.That is probably why you have such high head loss and getting only 70 GPM. For 10 jets, you should have at least 3" pipe with that...
-
-
-
mas985 replied to the thread No flow and no pressure on filter.That won't work. If you open the pump basket, the pump cannot create any suction. It can only prime when the pump lid is sealed. My...
-
I do suppose it’s possibly the SWG is creating pockets of air that aren’t being pushed out at lower RPM’s. But from what I have observed...
