Recent content by Limey

  1. Limey

    Intermatic pool timer issues.

    Just an update replaced the whole mechanism and all good now. I noticed the ON mechanism under the dial had a worn out, shame they don't make them like they used to. 365 x 6 approx 2000 on clicks before the metal wore out. Technically the tripper should wear out first but I guess it's done this...
  2. Limey

    Intermatic pool timer issues.

    Unrelated. I just noticed the ground earth wire has been removed from timer . I remember putting this on when I installed it 6 years ago. Since then I had a new pool pump and filter installed by a third party so they didn't attach it, but now it looks like they out the ground earth wire in a cap ?
  3. Limey

    Intermatic pool timer issues.

    Wow, mines exactly 6 years old as well. Looks like I'll be buying another one then.
  4. Limey

    Water evap and bucket test?

    I think the design of my pool could have been better. In respect to the skimmer line etc. Basically I get vortex in skimmer beyond two inches of water loss.
  5. Limey

    Intermatic pool timer issues.

    So if the new ON tripper fails to resolve the issue, is there another part that I can buy?
  6. Limey

    Water evap and bucket test?

    I'll read that article later , thanks. So any central Florida pool owners care to chime in about their water loss ?
  7. Limey

    Water evap and bucket test?

    I've found the bucket test not to be so accurate , am I correct in thinking that the surface area of the pool and the depth of the water in the bucket would less evap from the bucket? In any case, I'm central Florida and there has been no rain for a while. My in ground pool has lost 2 inches of...
  8. Limey

    Intermatic pool timer issues.

    If the contact point was worn , wouldn't that also prevent the off tripper from engaging? I went ahead and ordered some trippers. I replaced the whole unit about 6 years.
  9. Limey

    Intermatic pool timer issues.

    My pool timer won't turn on but will turn off. I checked the ON tripper and reseated it still no luck. Anything else to look for? The clock timer does rotate. Thanks.
  10. Limey

    Main drain cover half off

    Thanks for the advice. Fortunately for me the main drain doesn't truly function as a main drain. Meaning when I flip the valve lever main drain it causes pressure in the sand filter to immediately raise. That's the reason I unscrewed the cover in the first place. I wanted to see what was under...
  11. Limey

    Main drain cover half off

    The cover was held in place via two philips screws. The screws threaded into two holes that are located at 12 and 6 o'clock on the edge of the main drain plastic surround. I remember not being able to thread one screw fully , it would turn a quarter a turn and then fail to fully drive in any...
  12. Limey

    Main drain cover half off

    The main drain cover is in the deepest center part of my in ground pool. The cover is held in place with two philips screws. I remember I couldn't fully tighten one of the screws when they emptied to clean my pool around half a year ago after deck was remodeled. Any options for securing the...
  13. Limey

    Calcium Deposits on pool wall

    I think I've joined the calcium nodule gang. Noticed a few of these after the pool light was switched on at night at the bottom of the gunite pool. The pool was replastered in 2011, and the pool was emptied in March 2018 for remodel work of the deck . I guess that played a factor.
  14. Limey

    Bucket test after 6 days.

    Thanks , will do.
  15. Limey

    Bucket test after 6 days.

    How about the sunlight , I'm thinking it won't be as focused on the bucket with the high edges sitting in the corner compared to the wider area of the pool surface. I'm not sure , just talking really. ;-)