Recent content by jfjhfjvss

This has gotten better with time but still isn't accurate. Currently 3000ppm with Taylor kit, 3650ppm instant reading in Omnilogic. This feels like a happy medium where no matter who is right, the system will probably be fine.

Ok I did all of that. Showing 3000ppm on the Taylor test and 4100 instant salt on the Omni logic. What is going on?

I originally added the salt to it about 30 days ago, but it had dropped in the last month while we got delayed for the install (had a leak and other issues). Salt was about 2600 two days ago when I tested it. I added enough salt to bring it to 3200ppm but it didn't get there yet (obviously) so...

Just got my OmniLogic automation + TCELL-940 professionally installed yesterday. The Salt reading from the taylor test kit I have is 2800ppm. The salt reading from the OmniLogic is 3834ppm. One is too high and one is too low from ideal, but I'm not sure how to figure out which is correct. Any...

Got it, I had read 0 to -0.2 for salt water pools, so wanted to double check. Looks like when it gets warmer and the pool heater is on, the current numbers will be closer to -0.14 which should be fine. Thanks!

My pool is going to be converted to a SWG soon, so although I'm still using liquid chlorine, it is only temporary. As I was getting my water balanced to the right levels, I noticed my CSI seems a bit low. Curious how people would recommend raising it? I'm not sure if CH should be higher or...