Recent content by jeffj247

  1. J

    Salt test?

    Someone else took the sample down for me and he tossed the paper because it didn't have anything for me to add. So...all I know is it wasn't very far off 3200 or they would have had me add. I'll probably just wait till next month retest and see where I'm at then. Thanks
  2. J

    Salt test?

    The pool store also says the salinity is ok. So...I have the Taylor telling me 4000, the pool store and the Hayward telling me it's approx. 3200. What other test can I get to verify?
  3. J

    Salt test?

    It says T-15 on the cell itself unless its mislabled
  4. J

    Salt test?

    Hayward T-15 Salt 3100 Temp 85 Voltage 26.8 Amps 6.53 % Output 70P Instant Salinity -2800 Prod Name AL-0 Software revision r1.59...
  5. J

    Salt test?

    I just replaced the cell last year and checked/cleaned it before opening this year. However, I will do a diagnostic once I find it. Thanks
  6. J

    Salt test?

    Ok. I've done the Taylor test twice now and it comes out the same 4000. I'm using a Hayward cell and controller. It gives me a process to recalibrate. I'm not sure it will go that high but if it does it will read minerals as too high. Should I turn off the cell for a while and retest every week...
  7. J

    Salt test?

    I just received the Taylor sodium chloride K-1766 test kit. I got a reading of 4000 but my Hayward board reads 3100. Can I determine which one is correct?
  8. J

    Pool math and SWG FC levels

    I just started using the pool math app and it calls for FC of 1-3. I downloaded a lot of docs from the pool school and in the "Water balance for SWG's" it says the target FC level is 4-6. When I open the app it say recommended FC 1-3. Do I just ignore this and change target to 4, 5 or 6? Dumb...