Recent content by Hawkeyedave6

Thanks, I'm on it.

Sorry 9 psi and 16 psi. Okay, the igniter was cracked. I replaced it and the heater now fires up, runs for about 1-2 min and shuts down. Service light comes on as does HLS light. Heater continues to restart and shut down. Replace HLS?

Manufacturers date 5/18/2012 It's a salt water pool. All levels are within range. Only issue I've had is that my pump on low reads 900 psi, set at 2000 rpm, and high 1600 psi set at 3000 rpm. I'll need to look up how to do the other possible issues and reach back out. Thank you for your patience.

My pentair heater was working fine the other day, now when turned on I get the code 128 r13. It is opperated through an Easy Touch board. I start the heater, fan turns on, heating light flashes then goes solid, smell the gas, never ignites, heating light flashes again. It tries this 3 times and...

Thank you for your help. Complete success. Saved $600-700 with this little DIY!

Thank you! I was just holding the iron and solder getting ready to start. Now I'll test first.

I'm getting ready to solder on a new Pentair Easy Touch LCD Screen, can I reconnect and test it prior to soldering or does it need to be soldered first? I've never done this before.