Recent content by Donny

Hello, where did you order the RJ11 jack from ? Thank you. Also I was told the 1.59version of this board was not repairable ???

thank you

Hello folks, I'm having a steady RED NO FLOW on my Hayward Aquarite SWG. I replaced the flow switch. The board appears to be good. I think the RJ11 telephone jack is the problem. Anyone know if I can replace just the RJ11 jack ?? If yes, where could I order one ?? Thanks !

Thx guys.

I'm not sure if I have a leak or the water is evaporating naturally. I'm low about 2 inches a week now. Maybe slightly longer. Thoughts ?? Thank you.

I have a Hayward VS pump and love it. Very quiet.

Absolutely agree with Woody.

I have a gas heater rated at 250,000 BTU's. It heats my IG pool approximately 2 degrees an hour. So, whenever I want my water temperature increased, I use this formula accordingly. Also, when I do turn on the heater, I have it set to 89*. It will shut off automatically at 89*. Hope this lil...

I have the same one. I thought it was "snake oil". Wasn't sure how it could possibly do anything without being bonded. Now I know for sure. Pool supply store got me on this one.

They sell colored additive for cement/grout. Home Depot sells it in the cement section.

Rick I used Sensational Pools located in Orange County NY. The owner Glenn, lives in NJ. Very reasonable man and he is fairly priced. You will have to confirm he installs in your area. Tell him Donny from Rockland County recommended him. As far as the deep end, I would absolutely go for the...

Saw cutting is when a concrete saw is used to cut concrete. A gas powered concrete saw is common for this. IMHO you will have to saw cut the line in between the coping and concrete deck. This would be the edge of the coping that is butted up to the concrete, approximately 9 1/4 inches away...

As mentioned, definitely consult your local marine supply house and inquire what brand of paint they use for boats.

I would think this project will be a little involved for a DIYer. You are going to have to saw cut the edges of the coping (concrete side) along the entire pool and use a chipping gun to remove the coping. It will be a mess as all or most of the construction debris will fall into the pool. I...

(OLD THREAD, I KNOW) I have pretty much the same cement coping as you do. My PB drilled into the side of the coping in order to install my winter safety cover. I needed an attaching point for the cover. Use a hammer drill and a 1/4 inch bit. Really shouldn't be a problem. Yeah, it may chip a...