Recent content by DMan1979

  1. D

    A few frame posts not completely plumb, advice needed.

    Hello all, Installed my XTR last year and for the most part everything went smooth. A few of the posts shifted slightly and are no longer plumb. I'm the type of person that overthinks and worries about everything but my friends are telling me its fine. I added a 4" trailer tie down over the...
  2. right side.jpg

    right side.jpg

    • DMan1979
    • Media item
    • Comments: 0
    • Category: General Pool Photos
  3. left side_most lean.jpg

    left side_most lean.jpg

    • DMan1979
    • Media item
    • Comments: 0
    • Category: General Pool Photos
  4. left side_slight lean.jpg

    left side_slight lean.jpg

    • DMan1979
    • Media item
    • Comments: 0
    • Category: General Pool Photos
  5. left side_rear view.jpg

    left side_rear view.jpg

    • DMan1979
    • Media item
    • Comments: 0
    • Category: General Pool Photos
  6. D

    New Intex XTR owner with a few questions / concerns

    Just wanted to hop in and say thanks again to everyone
  7. D

    New Intex XTR owner with a few questions / concerns

    Thank you all for the quick replies. I forgot to mention that a few of the legs have sunk further down then the others... not by much but enough for me to notice with the naked eye. When I throw a level on the top beams (in between the T fittings) most of them are close to level but a few are...
  8. D

    New Intex XTR owner with a few questions / concerns

    Hello everyone, My wife and I just finished installing an Intex Ultra XTR 16x48 pool. Despite our best efforts to level the ground which required digging down almost 7 inches on one end (we had no idea our yard was so uneven) and then adding a layer of sand to fine tune everything, the...
See more
Top Bottom
Back