Recent content by db1234

The dark stains are just below the coping, I'll try your suggestions though. I didn't realize that was a gel coat on the fiberglass. I've learned to hate gel coat in my experience with an 80's fishing boat because I just can't ignore it so I spend a lot of time waxing. Some people cover their...

I've this pool since new, about 10 years but I'm still learning. I have at least 3 issues noted below. Over the years, the walls have gotten significantly stained white. I have no idea next steps with this. It's not bad looking when full (until some evaporation occurs). I can actually feel...

Hi, Hopefully problem solved. I kept the pressure regulator cracked open for awhile and now it's wife approved quiet! Fingers crossed I don't have an intake air leak. I took a picture of the clear plate on the pump to refer to. Thanks as always Doug

I have a whistling noise and I'm hoping you can help me track it down and eliminate it. I've listened in different spots through a piece of 30" copper pipe to narrow it down and I hear it the loudest (with my poor hearing) on the metal piece at the inlet and outlet from the heater. I haven't...

Thanks for the tip Jimrahbe. 2 seasons ago I couldn't start it. With the vent cover off I couldn't even turn it. I think it was replaced then. There are no signs of a leak at this time <Fingers crossed>

On the Pentair website under replacement parts I found the bonding post. Have a good season everyone. Thanks

Hi, There are no clamps but by the size of the connector on the bond wire, it must connect to one of the small screws at the vent end of the motor, does this seem right? Thank you

I just realized that only is the heater bonded but the pump should be as well. Where does that wire go? Thanks again

Thank you soon much!

Last year I took out my pump, taking photos of the wiring. Problem is I lost that phone and the pics. It's a 240v set up with a bare wire (obviously to green post). There is also black and white, I don't think it matters which goes to L1 and L2, can you confirm? Thanks