Recent content by cmac

Hello, hope everyone is ready for the Holidays! Learning curve is steep with all these Pentair products. Getting ready to install my Intellitouch system soon and was wondering what the J6 Aux Inputs are used for on this board (see attached pic). Searched through Intellitouch's many guides and...

On the main board has a sticker that shows version 1110 and a date 05/16/2008 if that helps. Now comes all the fun hooking everything up and testing. Will be flashing the firmware on both outdoor and indoor panels to the latest Intellitouch firmware 1.190. Thanks again.

Perfect, I bought a brand new service control panel on eBay for $275. Also, I just received from eBay a used Pentair IntelliTouch i9+3s Personality kit with Power Center (no SWG power supply unfortunately) and was surprised to see a 520508 part number on the personality board as it was sold to...

Hello, Does anyone know the difference between the Pentair Intellitouch Service Panel (520396) and the Pentair Indoor Control Panel (520138) models? Does both panel types give the same access to your system and features? I know the Pentair Intellitouch Service Panel can be used by service...

Thanks, I think I'll be fine since the only devices on that 30 Amp line from main to the sub panel will be Intelliflo VS 240v 3 HP pump - Full load 16 Amps, a 120v pool light incandescent - 4 Amps (will upgrade to LED in near future) and a SolarTouch control unit wired as 120v - 0.4 Amps.

Thanks, I will need to buy a wire gauge. Guessing it is probably 10 gauge wire.

Okay, the length is 34 feet from the main to the sub panel (same side of house). The sub panel is a Siemens W0408ML1125U Outdoor Main Lug Load Center, 125A, 4 Space, 8 Circuit. The wire size I don't know but there is a photo of the wire going into the sub panel from the main. How would I...

Thanks, got it now. There is only one load line going into the j-box coming from the house main panel on a 30 Amp 2-pole breaker. I'm planning to add a third regular 15 Amp breaker to the j-box for a Pentair SolarTouch unit. Do you think I should replace the 30 Amp breaker at the main for a...

Hello, good morning, Line 7 of the installation instructions says: "Check wiring to ensure that there are no shared neutral connections." Not sure exactly what that means and how to wire the GFCI breaker as there is only 3 wires going to the pool pump. 2 loads (black) and 1 green (ground)...

Hello, new to this forum and really like it! I just purchased a new Siemens QF220A Ground Fault Circuit Interrupter, 20 Amp, 2 Pole, 120V, circuit breaker to replace the existing non-GFCI 20 Amp, 2 Pole, 120V for a new Pentair Intelliflo VS pool pump. When I opened my sub-panel I noticed there...

Sounds good, wasn't sure, thanks.