Recent content by aviator79

Pull the whole circuit board out. I cant tell from pic if anything wrong and that CB looks different than mine but I would suspect a bad capacitor or something just like I had.

Pool is AG 15x30x4 so ~10k gallons. Using intex SWG/sandfilter/pump (Intex 2650 GPH Saltwater System & Sand Filter Pump Set | 28681EG (56681EG)) Opened pool in April but did not start running pump due to issues until about a month ago so got full of crud and turned green. Repaired sand filter...

Figured post here even though old thread rather than make a new one.. Just fixed mine (I think) Was a missing capacitor at c13 by the terminals top left in first pic. It is a 100uf 50v. Soldered new one on with negative lead toward terminals. Removed bad terminal forks, soldered new ones on...

So I am finally going to replace the sand in my intex sand filter after filling in 2013. Didn't use for a year or two so sand has 5-6 season on it and probably could use replacement. I struggle to get pool crystal clear at the beginning of the season and feel new sand could help. I also only...

Well it worked. I will try to upload pics but if other have this issue you can fix. If cant plastic welt could try zip ties or even gorilla or electrical tape...GOOD LUCK! Save me some money.

I cant get pics posted but I am assuming the plates should not touch so I plastic welded end together with plastic spacers. Now with only two connector prongs and 3 plates IDK if this was the right way to repair it. I do not have a new one to compare it to. As far as I can tell they look...

So I was getting a low salt warning after setting up pool. I just installed new liner. Tested salt and about 3200ppm so thats good. Removed plate and end is cracked at end and plate are touching so going to repair and see if works.

I guess it looks like part of the problem is sides or ends are not far enough out causing the squiggle on side which causes more force on side beams and hence why they angle and stick up. This seems like may be a lot of work to fix right so again im tempted to just clean foam and install liner...

Edit so removed bottom foam from edge and pool is pretty shot so 3rd post on will just be how i fixed for now. Pool needs too much work to properly fix where might as well buy new one so just going to do what i feel will work best to at least work for this season. So i made it thru last...