Report

almostakeeper

Well-known member From New Braunfels, TX.

Joined: May 20, 2020

Last seen: Friday at 6:50 PM

Start conversation

Latest activity Postings Media About

- A
  
  almostakeeper replied to the thread Pool Step Replacement.
  
  You'll probably lose the liner if you disconnect it from the steps. And you're correct about the top of the steps should be the same...
  
  Friday at 6:47 PM
- A
  
  almostakeeper reacted to HarryMichael's post in the thread This circuit breaker or change to GFCI… with Like.
  
  So, is this the one?
  
  Monday at 6:50 PM
- A
  
  almostakeeper replied to the thread This circuit breaker or change to GFCI….
  
  Just for clarity. Your new dbl 20 amp gfci will have a curly white wire. That white wire goes to the neutral side bar bus inside the...
  
  Monday at 6:49 PM
- A
  
  almostakeeper replied to the thread Going on Vacation.
  
  a cover, a few gallons of LC and fill a floater or two with some tablets and you're golden. Your cya could use a slight boost you'll get...
  
  Jul 27, 2022
- A
  
  almostakeeper reacted to Apsuhead's post in the thread RoBot maintenance. with Like.
  
  Exact same thing for me
  
  Jul 27, 2022
- A
  
  almostakeeper replied to the thread RoBot maintenance..
  
  Had to have my Warrior SE serviced under warrenty after 1 1/2 seasons. They replaced the motor.
  
  Jul 25, 2022
- A
  
  almostakeeper replied to the thread How long for FC to drop in SWG pool.
  
  Have a pool party, that'll knock it down bigly or turn the unit off for a day. FC at 9 is on the upper reaches, but only a tad. I like...
  
  Jul 23, 2022
- A
  
  almostakeeper reacted to YankeeTexan's post in the thread New Gunite Build in SETX with Like.
  
  Update time! Sorry for not keeping up but here's the recent progress. Tomorrow they're supposed to come and start the stone scape...
  
  Jul 23, 2022
- A
  
  almostakeeper reacted to HermanTX's post in the thread Plumbing disconnected with Like.
  
  1. it would still need to pressure up against something. Are the filter grids plugged? 2. Someone would need to fall onto it with...
  
  Jul 21, 2022
- A
  
  almostakeeper replied to the thread Plan on building a new pool in Houston area. Anything i need to change?.
  
  You should add an auto fill. They are cheap and well worth it. I lose about 3/8" in the dead of summer.
  
  Jul 20, 2022
- A
  
  almostakeeper replied to the thread Plumbing disconnected.
  
  I don't see any way that a pump has enough power to strip a large threaded fitting. Is it possible the installer accidentally cross...
  
  Jul 20, 2022
- A
  
  almostakeeper replied to the thread Cya level.
  
  It's been so hot and sunny here I had to do some adjustments. Was running the RJ-30 at 70% for 8 hrs most of June and then had to do a...
  
  Jul 20, 2022
- A
  
  almostakeeper reacted to bertschb's post in the thread Shocking after finding a dead animal with Like.
  
  Correct. If you keep your FC in the recommended range, you shouldn't need to shock or SLAM. The key is to maintain your FC at the...
  
  Jul 19, 2022
- A
  
  almostakeeper reacted to JoyfulNoise's post in the thread Wall anchor screws getting Rusted with Like.
  
  👍 Just use brass bristle brushes. Steel brushes can leave behind iron particulates that can then cause the rust to get worse.
  
  Jul 18, 2022
- A
  
  almostakeeper replied to the thread Pool complete Greenville, TX.
  
  It's been miserably hot here in Central Texas since mid May. Put down roughly 400' of new Zoysia, the sun would dry up the top in hours...
  
  Jul 18, 2022
Show older items
Loading…
Loading…
Loading…

Top Bottom

Search

almostakeeper

Find content

Latest activity Postings Media About