Latest activity Postings Media Albums About
-
-
Here is the same filter posted above in post #10, but after clearing a spring swamp. It looks much closer to yours. You... -
proavia reacted to Rancho Cost-a-Lotta's post in the thread Where would a SWG be plumbed? with
Like.
Something like... -
Ol, The large pipes under the decking have nothing to do with your sewer.. They are for moving or removing ground water.. Or they are...
-
Welcome to TFP. The 2 open ended pipes under the deck are most likely drainage such as a culvert may be under a driveway. The open...
-
I am leaving this post so maybe it will help someone else, but I looked closer and it was obvious they are drain plugs for my pump...
-
proavia replied to the thread What are these pipes?.Welcome to TFP! :wave: There are two capped pipes at the pad - the red handled one and the blue handled two pipes to the left of the...
-
proavia reacted to Rancho Cost-a-Lotta's post in the thread Calcium Hardness-Where does it come from? with Like.
A solar cover will slow down evaporation to help keep you from adding additional calcium. A water softener will remove the calcium...
-
proavia reacted to mknauss's post in the thread Calcium Hardness-Where does it come from? with Like.
Evaporation. The calcium stays in the pool water. You add more water (every day in summer) with calcium. It builds. You have very low...
-
proavia replied to the thread What order to plumb electrical heater..Booster pump after the SWG should be fine.
-
proavia replied to the thread Sheer descents turning off.From your single picture .... Are the shear descents the pipe marked waterfall? If so, place the closed arrow toward the Pool Returns...
-
proavia reacted to mknauss's post in the thread TFPC Recommended level vs manufacturer level with Like.
A heat pump is not effected by low CH. Neither is your paver stone (not in contact with the pool water). You do not need to add any...
-
Your TA of 110 will not allow your pH to stay at 7 for long. Start the
-
If the pool holds FC more than 30 minutes, you do not have ammonia. Raise the CYA to 30 ppm and start the SLAM process, as necessary.
-
proavia replied to the thread Sheer descents turning off.Post a few pics of your equipment pad from a few different angles so we can see what you have. Once we see an overall layout of the pad...
-
proavia replied to the thread Pool Electrical Issues.This may be the breaker in his pic...
-
-
Loading…
-
Loading…
-
Loading…
-
Loading…