Latest activity Postings Media Albums About
-
-
Jimrahbe replied to the thread Nautilus CC owners, can you describe how your robot navigates?.Allan, For you own sanity, I suggest that you not watch it run... Somehow.. it knows when you are watching.. :mrgreen: I only worry... -
Jimrahbe replied to the thread Nautilus CC owners, can you describe how your robot navigates?.Allan, It is not designed to go all the way up the wall on each pass... I am not sure of the exact ratio, but my guess is that it goes...
-
Jimrahbe replied to the thread I’m new to this and I was wondering about what controls the strength of the skimmer suction? Can anyone answer this question please?.Harvey, Patience is your friend when it comes to skimmer operation. :mrgreen: Skimmers are not designed to reach out into the pool...
-
Jimrahbe replied to the thread Pool vacuum confusion….p2, See this review...
-
Jimrahbe replied to the thread Pentair ic40 flashing salt level good low (red) (green) before pump even kicks on..The old IC40's had 4 wires.. You can use the 3 wire flow switch to replace a 4 wire flow switch. The new IC40's have 3 wires. You...
-
Jimrahbe replied to the thread Help please! Placement of SWG cell on Split Return Plumbing?.el, I would want the SWCG to feed the three returns in the sidewall of the pool. Does not make sense to me to put the SWCG on a water...
-
Jimrahbe reacted to ColoradoPool2022's post in the thread Featured Spa not maintaining set tempurature with
Like.
I just spent an hour on the phone with Pentair tech support. They were trying all sorts of usual trouble shooting things- adjusting... -
Jimrahbe replied to the thread Featured Spa not maintaining set tempurature.2022, You should not have to push any buttons on the heater.. Just leave it in the Pool mode if that works. As a test, with the...
-
Follow TFP Pool Care Methods and the correct and weekly shocking is never required.
-
Jimrahbe replied to the thread Featured Spa not maintaining set tempurature.2022, I went out to my system and used ScreenLogic to increase or decrease the set point.. Heater enable is on.. Every time I move...
-
Jimrahbe replied to the thread Featured Spa not maintaining set tempurature.2022, It does not look like your SWCG transformer is wired to the pump/filter relay as "Required"... If your cell has any lights on...
-
Jimrahbe replied to the thread Featured Spa not maintaining set tempurature.2022, From the EasyTouch's point of view, it just tells the heater to heat, or it does not.. It does not care if the system is in the...
-
Jimrahbe reacted to pjt's post in the thread Cartridge filter was very dirty but PSI did not rise. with Like.
Keep a disposable hairnet in your skimmer(s).
-
Jimrahbe reacted to proavia's post in the thread Cartridge filter was very dirty but PSI did not rise. with Like.
While there may be a bit of debris, there isn't much small, fine dirt visible. What exact filter manufacturer and model number (add...
-
Jimrahbe replied to the thread SWG ic40 Cold Light On.RW, You do not have a Pentair IC40.. Not sure what that is, but none of the 'real' IC40 documentation will match what you have...
-
-
Loading…
-
Loading…
-
Loading…
-
Loading…