Latest activity Postings Media About
-
-
Bill1974 replied to the thread Help I think my pool is leaking!.Thinking about your leak and my own past leak experiences. I don't have a warm fuzzy feeling that this is the only leak. For such a... -
Bill1974 replied to the thread Adding swcg, where to install?.Moving the filter a bit and maybe changing the orientation of the inlet/outlet. Also there should be a 6" to 12" of straight pipe...
-
Bill1974 reacted to SJPoe's post in the thread Drop In VSP Replacement for a JHPU1.5 (single speed)? with
Like.
I mean....not really. I guess you could have a long debate about conductor sizing, cross-sections, internal resistance and heat losses... -
Bill1974 replied to the thread Upgrading from cartridge to sand filter.If you have room to add a sand filter, I would add one (plumb it in parallel and not series) using a couple of 3 way valves in so you...
-
Bill1974 replied to the thread Hayward Sand Filter Sand Screen Under Drain Broken and Stuck.I would guess it's just pushed in (not sure from the inside or outside). Below are a couple of images from the manual. 2006 and newer...
-
-
-
-
-
-
Bill1974 replied to the thread Repair vs. Replace Hayward Multi-port valve for S-200 filter.You have to weigh the difference in cost for replacing or rebuilding. I don't think the cost is that much to replace. But be aware...
-
Bill1974 replied to the thread Help I think my pool is leaking!.Kudos for diying this project. I did this on my steel wall in ground pool, I can imagine how much more work it is dealing with...
-
Bill1974 replied to the thread Help I think my pool is leaking!.I would not trust this bucket test. Concrete is like a sponge. If that paver was not saturated before this test was started it's going...
-
Bill1974 replied to the thread Pool plumbing question from New pool owner.Lid on the pump, some threaded connected on the inlet side, the union the inlet is letting in the air. Or maybe a glue joint is...
-
Bill1974 replied to the thread Pool plumbing question from New pool owner.Looking over your equipment image. Looks like you have somewhat restrictive plumbing. Three 1-1/2" inlet lines and one 1-1/2" return...
-
Bill1974 replied to the thread Pool plumbing question from New pool owner.The leak would be sucking in air, so not the easiest to find. It's unlikely that you would be able to tell from using soap and bubbles...
-
-
Loading…
-
Loading…
-
Loading…
