Latest activity Postings Media About
-
-
mas985 replied to the thread Hayward H400 - Bizzare Issue + IF code.But did you first prime the flame tubes with the black pipe in the downward position and trying to light the burners? This will fill the... -
mas985 replied to the thread Hayward H400 - Bizzare Issue + IF code.Did you try it with the gas completely shut off? With the gas shut off, it should not continue to burn.
-
mas985 replied to the thread Hayward H400 - Bizzare Issue + IF code.You said that the ignitor glows in both cases correct? This is just pure speculation but what if the gas pressure is actually too high...
-
mas985 replied to the thread Hayward H400 - Bizzare Issue + IF code.The gas comes out of the nozzles so I don't see how that is possible unless it is simply burning off what was already in the burner...
-
mas985 replied to the thread High FC and TA, What should I try to tackle first....If your PH is not rising, I would leave TA alone. CSI is a little over 0 so scaling could become an issue with the SWG but with pucks...
-
mas985 replied to the thread Motor replacement.On low RPM, the difference in efficiency does not amount to much. For example, the SuperFlo VS (1.5HP) uses about 231 watts at 35 GPM...
-
mas985 replied to the thread Motor replacement.There is really no such thing as an efficient single speed motor. While some are better than others, it is a very small difference. To...
-
mas985 replied to the thread Liquid Chlorine Degradation.Storage temperature and light exposure have the biggest impacts...
-
mas985 replied to the thread 110 or 230v?.True but what I meant was that if you compared the 115v version with a 230v version, the windings are fed in parallel and series...
-
I don't think that there are any two-speed pumps that take dual voltage.
-
mas985 replied to the thread 110 or 230v?.In an induction motor, the heat loss is exactly the same and the current in the windings is exactly the same for both voltages. There...
-
-
-
mas985 replied to the thread 110 or 230v?.Replacing a pool pump in the US pretty much means you will be going with a VS pump and those are almost all 230v except for some RPM...
-
mas985 replied to the thread Traditional air venturi vs blower for spa.Then I would get the PBs input as what is possible given the current situation. They are responsible in the end.
-
mas985 replied to the thread Traditional air venturi vs blower for spa.However, the bottom of the spa is below ground level, no?
-
-
Loading…
-
Loading…
-
Loading…
