Latest activity Postings Media About
-
-
mas985 replied to the thread Pump size and number of jets..The plumbing around the spa looks fine, I just don't understand why the PB used such small pipe from the spa to the pump. Any other... -
mas985 replied to the thread Pump size and number of jets..Not without separate suction lines and return lines going to pad. The current plumbing (1 1/2"?) is way too small for spa jets. That...
-
mas985 replied to the thread Pump size and number of jets..The blower attaches to the air line, not the jet water lines. That just means you have two air lines. With a suction, return and air...
-
mas985 replied to the thread Pump size and number of jets..One more pont, you said there were two loops but does each loop have it's own suction line and return line back to the equipment pad? If...
-
mas985 replied to the thread Pump size and number of jets..If you are talking about a Hartford loop, that goes near the spa jets, not the blower.
-
mas985 replied to the thread Pump size and number of jets..Does each loop have equal number of jets and are the jets the same size? Also, make sure the PB installs a Hartford loop on each of the...
-
mas985 reacted to Packfan's post in the thread My Aqua Logic (AQL-PS-8) keeps going into Service Mode when running Aux 3 Edge Pump with
Like.
The local keypad is what goes into "Service Mode". I could take it off and perhaps spray some electronic contact cleaner on it. Though... -
mas985 replied to the thread Pump size and number of jets..You need to go by GPM not HP. If you are set on 12 jets, I would go with two plumbing loops with a VS pump and 6 jets on each loop...
-
mas985 replied to the thread Dolphin gear is slipping.Those are plastic hydraulic bearings so they are designed to wear like that and eventually have to be replaced. No different than the...
-
mas985 replied to the thread No flow and no pressure on filter.Looks like the screw head really got chewed up. Something else may have failed as well. Is the diffuser and volute still in good condition?
-
mas985 replied to the thread URGENT - Pool Elevation Needed. Excavation is literally here digging and there is confusion..With 2x5' sheers you will need at least two pumps if you want to run the sheers and anything else at the same time. Recommendations for...
-
-
-
mas985 reacted to cwscott's post in the thread Recommended Salt Levels for Salt water Pools with Like.
i like this thought process and it makes sense to me.
-
mas985 replied to the thread No flow and no pressure on filter.Yes, it means that the impeller has dislodged from the motor shaft. As to fixing it, it most likely is the impeller that broke and yes...
-
Unless you have unique circumstances, you don't need a dedicated pump for your water features. My setup is almost the same as yours and...
-
-
Loading…
-
Loading…
-
Loading…
