Latest activity Postings Media About
-
-
JJamesW replied to the thread Polaris PB4SQ Booster Pump leaking from body.Pictures?
-
JJamesW replied to the thread New to pools entirely.Just don't forget.
-
JJamesW replied to the thread a Q about phospates.Phosphates are reported in parts per billion, so while the number seems high, it is really only 0.655 ppm, which is low. Forget about...
-
JJamesW replied to the thread Featured Copper source? Hair turning green.For dissimilar metals, the weaker metal will be preferentially corroded over the more noble metal. The weakest (least noble) will be a...
-
JJamesW replied to the thread Featured Copper source? Hair turning green.I doubt that the fittings are the source of copper. You can look inside them to see if they are corroding. Maybe a service person...
-
JJamesW replied to the thread Salt cell temp sensor error message.That's true for the IntelliChlor, but I do not think that it is true for the Aquarite.
-
JJamesW reacted to JoyfulNoise's post in the thread Featured Copper source? Hair turning green with
Like.
It's bad practice to mix metals. Yes, there's lots of conflicting advice out there but the UPC is pretty clear that it should be... -
JThis would look cooler:
-
JJamesW replied to the thread Standalone vacuum pump.Put a valve on the discharge (Not the suction) to control the flow rate. This allows you to control the suction as well as the water...
-
JJamesW replied to the thread Does this make sense?.You should not have your Polaris suction intake before the flowmeter. Does the pump flow reading match the flowmeter reading? What...
-
JJamesW replied to the thread Featured Copper source? Hair turning green.You can look into the fittings to see if there are any signs of corrosion.
-
JJamesW replied to the thread Does this make sense?.An 8 hour turnover is about 85 GPM. DE is rated at 1 gpm/sqft, so you need at least 85 sqft of DE fiter. For cartridge, you need at...
-
JJamesW replied to the thread Does this make sense?.Commercial pools have to meet turnover requirements and flow rates. What is your required turnover time and required flow rate?
-
JJamesW replied to the thread Failing T-15 SWG Cell Experiment.It's pretty simple. Just make a manifold like this and install up to 24 cells. You can use valves and valve actuators to open and...
-
-
JMaybe if I had nothing better to do and owned a plumbing supply warehouse.
-
-
Loading…
-
Loading…
-
Loading…
