Latest activity Postings Media About
-
-
PoolGate replied to the thread Pool Temp and Opening.Opening below 60 is what TFP recommends. My pool was right in the upper 50's all that week and barely got to 60. After I opened, the... -
PoolGate replied to the thread Let’s see your water after removing winter cover!! *PICS THREAD*.Your filter will still need to catch the dead algae as you SLAM. When mine was finally clear I cleaned the cartridges and the filter out...
-
PoolGate replied to the thread Anyone know a concrete guy? ;^).Nice! Where are you in MD? 2 of my subs fought over who was supposed to do the grading as well. I ended up doing most of it myself to...
-
PoolGate replied to the thread Oxalic acid in pool.I looked up information about this and it seems it is used as a cleaning product. It shows as fairly toxic and dangerous. Hopefully one...
-
PoolGate replied to the thread Repair vs. Replace Hayward Multi-port valve for S-200 filter.These are designed to be serviced. New spider gasket is probably all it needs. I'd go the gasket route first as it's a lot less work.
-
PoolGate replied to the thread Drain pipe for JCF425 cartridge filter?.Yeah should work fine as long as you can match the proprietary threads and make sure it's water tight.
-
PoolGate replied to the thread 2 years after replastering… Calcium high and dark stains.You are over the max. Biggest issue with high CH is your SWG may start to get calcium deposits on it. It can also cause scaling on the...
-
S, Stick with 240 volts.. There is no real advantage to 120 volts. If you are looking for 'efficient', then I suggest that you buy a...
-
PoolGate replied to the thread 0 CYA and 0 FC. Need advise.Sounds like you are making great progress! Great news! For the ducks? SSS
-
Ok, so I know you all won’t be too happy with me, but with ducks invading my pool and expelling waste into it and me working full time...
-
PoolGate replied to the thread 110 or 230v?.I don't think there are any efficiency gains. But most pool pumps are 220 volt. Especially if you are going to go with a Jandy VSP. Not...
-
PoolGate replied to the thread Jandy Salt Cell 1400 Code 121.I believe it only produces 1/2 as much. The cell has an electrical lead at each side of the cell (plus the center). When energized, I...
-
The IntelliFlo at 2,070 RPM uses about 350 watts (at 10 gpm) to about 650 watts (80 GPM) depending on the flow, which depends on the...
-
PoolGate replied to the thread 2 years after replastering… Calcium high and dark stains.You water parameters are all off. CH should be like 250. Only a water change is going to fix that. Your TA is also very high. CSI is...
-
Power usage goes up with less restriction. It is counterintuitive, but less restriction causes more flow and higher power.
-
-
Loading…
-
Loading…
-
Loading…
