Hi all.
I have joined in the hope that you all might be able to help with sorting the chlorine loss in my Pool.
Essentially over the last couple of months I have been constantly losing chlorine no matter the level of my chlorinator.
I have conducted two slams. The first with low stabilizer where I maintained chlorine level at 10pm for about a week until lost less than 1ppm over night and less than 1 combine chlorine. However within two days of completing this, chlorine dropped to 0 again.
Unfortunately during these two days I boosted stabilizer to 60- 70 ppm. I then did another slam with chlorine at 24 ppm. Again passed the over night test after about 5-6 days. With SWG set at 25% dropped to 5ppm chlorine over 5 days. I then increased SWG to 75% and maintained 4-5 ppm chlorine for two days. To increase chlorine levels I increased SWG to 100% but two days later was back at 0ppm chlorine!!!
I am at a loss for what is going on. Pre-solar heater I could have the SWG at about 40% and would be no problem. I got the solar heater two summers ago and had a similar problem but not to the same extent.
Any advice would be greatly appreciated.
Pool details are set out below.
Pool details:
Fibreglass
55000 liters
SWG V25 Viron with cell replaced 12 months ago. Running 12-13 hours a day
Pool cover used when not in the pool
Pool water temp at 30C with solar water heater
Cheers
I have joined in the hope that you all might be able to help with sorting the chlorine loss in my Pool.
Essentially over the last couple of months I have been constantly losing chlorine no matter the level of my chlorinator.
I have conducted two slams. The first with low stabilizer where I maintained chlorine level at 10pm for about a week until lost less than 1ppm over night and less than 1 combine chlorine. However within two days of completing this, chlorine dropped to 0 again.
Unfortunately during these two days I boosted stabilizer to 60- 70 ppm. I then did another slam with chlorine at 24 ppm. Again passed the over night test after about 5-6 days. With SWG set at 25% dropped to 5ppm chlorine over 5 days. I then increased SWG to 75% and maintained 4-5 ppm chlorine for two days. To increase chlorine levels I increased SWG to 100% but two days later was back at 0ppm chlorine!!!
I am at a loss for what is going on. Pre-solar heater I could have the SWG at about 40% and would be no problem. I got the solar heater two summers ago and had a similar problem but not to the same extent.
Any advice would be greatly appreciated.
Pool details are set out below.
Pool details:
Fibreglass
55000 liters
SWG V25 Viron with cell replaced 12 months ago. Running 12-13 hours a day
Pool cover used when not in the pool
Pool water temp at 30C with solar water heater
Cheers