Our pool was completed 4 weeks ago and our pool builder added 6 bags of salt this morning. Said to add two more in a couple of days if red light was on salt cell. We have Pentair and my app says it’s at 4450ppm. I know that is a high reading. Do I go ahead and drain a little and add fresh water or wait to see if it balances out? Just didn’t know if it took awhile to regulate since this is the first time salt has been added.
Salt added to new pool today. High ppm
- Thread starter jendelta
- Start date
- Jul 21, 2013
- 52,451
- Pool Size
- 35000
- Surface
- Plaster
- Chlorine
- Salt Water Generator
- SWG Type
- Pentair Intellichlor IC-60
Welcome to TFP.
How many gallons in your pool?
You need a Taylor K-1766 Salt Test kit to confirm your salt level and that nothing is wrong with your app.
How many gallons in your pool?
You need a Taylor K-1766 Salt Test kit to confirm your salt level and that nothing is wrong with your app.
I will be sure to brush extra.
This is how the valve has been since day 1.
Attachments
Most likely, the salt is on the floor and getting sucked into the main drain.
www.troublefreepool.com
PoolMath
www.troublefreepool.com
PoolMath
Discover the calculator behind the perfect pool, PoolMath. Dealing with pools has allowed TFP to become the original authors of the best calculator on the net.
www.troublefreepool.com
I never saw a reading prior to the salt being added. Yes, six bags total.
- May 3, 2014
- 58,353
- Pool Size
- 6000
- Surface
- Fiberglass
- Chlorine
- Salt Water Generator
- SWG Type
- Pentair Intellichlor IC-40
Remember that the Intellichlor only reports the salinity at start up and after twelve hours of continuous use. So the current data may be way off of reality. You should have the SWCG powered off until you test the water salinity at the proper level.
Thanks! I haven’t touched any of the equipment. Looks like everything is on though. Haven’t had pool school yet so I’m not 100% familiar with everything yet.
- May 3, 2014
- 58,353
- Pool Size
- 6000
- Surface
- Fiberglass
- Chlorine
- Salt Water Generator
- SWG Type
- Pentair Intellichlor IC-40
Very sad that pool builders add salt with the SWCG powered. High levels of salt pumped through them can damage them. I suggest turning off the pumps and brush the pool really well.
Thanks! Shut it down and brushed again. It’s now reading 3300ppm.
- Nov 30, 2019
- 852
- Pool Size
- 8500
- Surface
- Fiberglass
- Chlorine
- Salt Water Generator
- SWG Type
- Hayward Aqua Rite (T-15)
My PB (or the contractor he hired to open my pool) never checked salt and just dumped in 8 bags and turned the SWG on. I didn’t know enough to question anything at the time. I checked my salt with a Taylor kit after the cell failed a week later. 5400 ppm.