Moderator comment: This post was separated out from this thread: 32X16X52 Intex Rect Pool - Paver spacement/measurements
I just purchased an intex rectangle pool and wondered about the foam padding you put down. Was it a stiff foam insulation or was it a soft type of padding you used?
Thank you
I went with the 1/2 in padding. Did you find that the measurements are a little off in that table? If I was going to start over I would have laid the foam padding at 12X24 and butted the pavers right up to the foam padding. It would have saved me a lot of time laying out and squaring off the area with lines. I took a lot of time putting down the layout lines so that the measurements of 13'10" and 25'10" would put the legs right in the middle of the pavers but they are off from center about 2 inches. And according to the table the bottom of the pool is 12X24 and that isn't even close as I can see but I only have about a foot of water in the pool so far.
I just purchased an intex rectangle pool and wondered about the foam padding you put down. Was it a stiff foam insulation or was it a soft type of padding you used?
Thank you