I have a AquaLink Rs system. The documentation for the salt cell kit reads "The new AquaPure sensor does not need the flow adapter board. Do not use the part with a flow adapter board".
Reading the installation instructions I still cannot figure out where I am suppose to connect the AquaPure sensor.
For a while they were putting out an adapter that went on the plug end. It looked like a little green computer board that you plugged in to the board first. Yours may not have had one. Just plug the white end straight to the board.
This is a normal operation. Unit should display cell reversing every other 3 hours of operation. This is an attempt to clean the cell. If you note the system in "cell reversing" mode, turn the power to the unit off 15 seconds, then back on. After the wait state, about 4 min, unit should resume without cell reversing.
The documentation for the salt cell kit reads "The new AquaPure sensor does not need the flow adapter board. Do not use the part with a flow adapter board".
Reading the installation instructions I still cannot figure out where I am suppose to connect the AquaPure sensor.
Hello , This thread has been inactive for over 60 days. New postings here are unlikely to be seen or responded to by other members. For better visibility, consider Starting A New Thread.
Welcome to TFP! For a wealth of pool care information please check out our free Pool School. If you are in need of specific help then we encourage you to Register and ask us here in the forum!