Hi all,
I'm preparing to replumb my equipment pad. To many leaks and to many patchs, time to do it right, any tips are welcome. I've been looking at the Jandy neverlube valves vs a less expensive ball valve with a union on either side for easy replacement should it fail, thoughts?
For pipe, is schedule 40 or schedule 80 typically used? For all the various fittings and unions, are the box store components reliable enough? I'm under the impression that they are the same regardless of where I get them.
I'm removing a heater and simplifying the run. I'll post before and after pics eventually when done.
Thanks
I'm preparing to replumb my equipment pad. To many leaks and to many patchs, time to do it right, any tips are welcome. I've been looking at the Jandy neverlube valves vs a less expensive ball valve with a union on either side for easy replacement should it fail, thoughts?
For pipe, is schedule 40 or schedule 80 typically used? For all the various fittings and unions, are the box store components reliable enough? I'm under the impression that they are the same regardless of where I get them.
I'm removing a heater and simplifying the run. I'll post before and after pics eventually when done.
Thanks