I just received a new PSI glycerin filled gauge from TFTestkits. I wrapped the threads with teflon tape and screwed it in. I noticed that it didn't seem to tighten well after several turned unlike the old one I took out. I turned the pump on and seconds later, the gauge blew out. I tried wrapping more tape on it with the same effect. So I put the old one back on. Any recommendations on how I can get a tighter fit?
Hayward 244T sand filter PSI gauge won't stay on
- Thread starter AnesthetistBulldog
- Start date
Most filters are 1/4" npt for that fitting. What kind of filter do you have. I am a minimalist concerning teflon tape.....3-4 wraps should be plenty.
No other reported problems with the threads of which I am aware.
No other reported problems with the threads of which I am aware.
Wow, not sure on this situation. Make sure the threads are the same. Could be the problem. Be careful not to damage the threads on the valve.
The hayward multiport valves tend to be extremely fragile. Finger snug is all I ever tighten a gauge into them. It would be really hard to put a pressure gauge that is the wrong size in a valve, so I am betting that the valve is broken.
