Hi,
I installed the Hayward AQL-WW-P-4 wired remote today and connected the low voltage 4 wire connectors to my Aqua Plus control panel. The remote comes to life, shows version info, salt levels, air temp, etc. but none of the remote buttons do anything (except beep). I can't turn lights on or off, and I can't scroll or change any menus. I checked the Aqua Plus to make sure the remote capability was enabled, which it was.
Any else run into something like this? Not sure if there is something odd with the connection, the unit itself, or a config. Any assistance would be appreciated.
Bryan
I installed the Hayward AQL-WW-P-4 wired remote today and connected the low voltage 4 wire connectors to my Aqua Plus control panel. The remote comes to life, shows version info, salt levels, air temp, etc. but none of the remote buttons do anything (except beep). I can't turn lights on or off, and I can't scroll or change any menus. I checked the Aqua Plus to make sure the remote capability was enabled, which it was.
Any else run into something like this? Not sure if there is something odd with the connection, the unit itself, or a config. Any assistance would be appreciated.
Bryan