I have a Jandy AquaPure 1400.
Newish cell. Only about one year since replacement.
Newish back board. 8 Months +-
I am always struggling with build-up of calcium in the cell.
The salt content is currently too high. 3800-4000. The reading fluctuates. This is the first time that I have had the salt level too high.
After a lot of rain (pool draining), I had the local pool store test the water. It tested only 1100, so I added 200lbs, per their recommendation.
I am not currently getting any codes, but it seems like it is always in "cell reversing" mode.
The "cell on" light will light, for just a few seconds, then go off.
I have not read these symptoms in anyone else's forum posts.
Does this sound familiar to anyone?
Thanks in advance.
Mike
Newish cell. Only about one year since replacement.
Newish back board. 8 Months +-
I am always struggling with build-up of calcium in the cell.
The salt content is currently too high. 3800-4000. The reading fluctuates. This is the first time that I have had the salt level too high.
After a lot of rain (pool draining), I had the local pool store test the water. It tested only 1100, so I added 200lbs, per their recommendation.
I am not currently getting any codes, but it seems like it is always in "cell reversing" mode.
The "cell on" light will light, for just a few seconds, then go off.
I have not read these symptoms in anyone else's forum posts.
Does this sound familiar to anyone?
Thanks in advance.
Mike