I have an Intermatic automation system (PE635 and PE953 handheld) and have recently added the CA3750. The CA3750 is wired to handle my spa blower with one circuit and a waterfall with the other (2 X SPST). I'm a little confused on how to program it with the Z-wave.
Currently, I can turn the blower on and off with the include switch on the front of the device, however, it does not turn on the motor. The label on the front says when in the 2XSPST setting, you can use the switch for Off/Off and On/Off. This is confusing to me as it should be Off/Off, On/Off, Off/On, and On/On? In any case, I can't get the motor to turn on....the blower just turns on and off.
With my handheld, I am able to get the spa blower to turn on and off using a scene, but I'm not sure how to program the motor. As I understand it, when you have it set to 2XSPST, you get two different Z-wave devices.
I'm not very familiar with Z-wave, so any help would be greatly appreciated!!
Bill
Currently, I can turn the blower on and off with the include switch on the front of the device, however, it does not turn on the motor. The label on the front says when in the 2XSPST setting, you can use the switch for Off/Off and On/Off. This is confusing to me as it should be Off/Off, On/Off, Off/On, and On/On? In any case, I can't get the motor to turn on....the blower just turns on and off.
With my handheld, I am able to get the spa blower to turn on and off using a scene, but I'm not sure how to program the motor. As I understand it, when you have it set to 2XSPST, you get two different Z-wave devices.
I'm not very familiar with Z-wave, so any help would be greatly appreciated!!
Bill