Hey Folks,
I have two Hayward Colorlogic Lights, 1 in my pool and 1 in my spa. There is a Jandy Aquaklink System controlling them. My problem is, I cant get them to sync up with eachother or the PDA. I have read the sync procedure, it just doesn't make sense to me. It talks about turning on then off within so many seconds etc to cycle to the colors. The thing is that my PDA has the available colors listed so for example I will select emerald for the pool light on the PDA and it will cycle through 4 or 5 colors and end up on sangria. I will then depress the pool light button, then depress again within 5 seconds to keep from turning light off and select a different color. Now say I select deep blue sea, the same thing happens; "please wait while cycling to chosen color" goes through 4 or 5 colors and ends up on afternoon skies. I will go through this process several times before it actually gets to the color I chose. Then on to the spa light where I go through the same song and dance until I get it to the color chosen on the PDA. When it is all said and done, while I may have the actual color specified on the PDA showing on the light it is next to impossible to get the pool light and the spa light to match. What gives, I have been dealing with this for the 3 1/2 years since we built the pool; any ideas. I am tired of taking 20 minutes to turn on my pool lights. Thanks
Eric
I have two Hayward Colorlogic Lights, 1 in my pool and 1 in my spa. There is a Jandy Aquaklink System controlling them. My problem is, I cant get them to sync up with eachother or the PDA. I have read the sync procedure, it just doesn't make sense to me. It talks about turning on then off within so many seconds etc to cycle to the colors. The thing is that my PDA has the available colors listed so for example I will select emerald for the pool light on the PDA and it will cycle through 4 or 5 colors and end up on sangria. I will then depress the pool light button, then depress again within 5 seconds to keep from turning light off and select a different color. Now say I select deep blue sea, the same thing happens; "please wait while cycling to chosen color" goes through 4 or 5 colors and ends up on afternoon skies. I will go through this process several times before it actually gets to the color I chose. Then on to the spa light where I go through the same song and dance until I get it to the color chosen on the PDA. When it is all said and done, while I may have the actual color specified on the PDA showing on the light it is next to impossible to get the pool light and the spa light to match. What gives, I have been dealing with this for the 3 1/2 years since we built the pool; any ideas. I am tired of taking 20 minutes to turn on my pool lights. Thanks
Eric