From the manual.
To Operate the Light and Change Colors
Turn the light ON. The fi rst time the light is turned on,
the color sequence begins with the Alpine White. To
change the color, turn the light OFF and then ON within
three (3) seconds. Continue turning OFF and ON until
the desired light color mode is reached. See Table 2 for
the color mode sequence.
Table 2. Jandy Laminar Jet with LED Lights
Sequence
Sequence Order Color Modes
1 Alpine White
2 Sky Blue
3 Cobalt Blue
4 Caribbean Blue
5 Spring Green
6 Emerald Green
7 Emerald Rose
8 Magenta
9 Violet
10 Slow Color Splash
11 Fast Color Splash
12 America the Beautiful
13 Fat Tuesday
14 Disco Tech
Here is what you need to synch the lights.
NOTE When the light is turned OFF for more than
seven (7) seconds, it will remain in the color set
that is currently active. When the light is turned
back ON, the light will be on the same color set.
7.2 To Reset to the Beginning of the Color Sequence
Turn the light OFF, wait four (4) to six (6) seconds, then
turn ON, the light will return to the beginning of the
color cycle (Alpine White).
NOTE If an AquaLink® RS control system is being
used the color set can be selected using the
controller.
NOTE To synchronize colors on multiple Jandy
WaterColors light systems and Jandy Laminar
Jets with LED Lights wired to separate
switches, preform the above actions on all of the
switches simultaneously. All Jandy WaterColors
lights and Jandy laminar jet with LED lights will
synchronize automatically if activated by the
same switch. No other accessories are required.