Aquic Logic T-15 reading HIGH temperature ... changed temperature sensor but ....

Jump to latest Follow Reply
F

flynlady

0
Sep 20, 2014
1
Prairieville, LA
Cell is clean but showing low salt, so turning off. According to Leslie's, salt is at 3600 ppm. The temperature was showing VERY high, so we changed the temperature sensor. It's STILL showing HIGH temperature. We're not sure what to do next. Is there a reset that we're missing? :brickwall:

The circuit board was replaced about 2 years ago, so we checked to make sure nothing burned and no burn smell. Cell is about 2 years old but haven't taken it to be checked.

Help is GREATLY appreciated!!!
 
There should be a temperature sensor in the cell and one installed in the plumbing. What temperature does each report?

What do all of the diagnostic readings show?

What temperature does the air temperature sensor report.?
 
You must log in or register to reply here.
Thread Status
Hello , This thread has been inactive for over 60 days. New postings here are unlikely to be seen or responded to by other members. For better visibility, consider Starting A New Thread.
Top Bottom
Back
Jump to latest Follow Reply