Does anybody know how to program Aqua Rite PS 8 so that the timer can run the filter in spillover mode for an hour and then run in pool only mode for the rest of the program? I can only figure out how to do one or the other in configuration menu. Thanks.
Aqua Rite - How to Program Spillover
- Thread starter mcdickey
- Start date
- May 3, 2007
- 16,878
- Pool Size
- 20000
- Surface
- Plaster
- Chlorine
- Salt Water Generator
- SWG Type
- Hayward Aqua Rite (T-15)
First, I think you have an AquaLogic and not an AquaRite. They are different.
Second, the ability came in later releases so what is your firmware version? It may not support a spillover run.
Second, the ability came in later releases so what is your firmware version? It may not support a spillover run.
Yes. I have AquaLogic PS8. I see 'Main Software Revision 2.66' under the Diagnostic Menu. Is that the firmware version?
- May 3, 2007
- 16,878
- Pool Size
- 20000
- Surface
- Plaster
- Chlorine
- Salt Water Generator
- SWG Type
- Hayward Aqua Rite (T-15)
Yes, that is the firmware version. Unfortunately, I don't think that version supports timed spillover. You have a choice of pool OR spillover but not both.
That's what I suspected based on the options in the configuration menu. Thank you for confirming.