Pool is looking good. I added CYA about two weeks ago and if I'm reading the test results correctly, my CYA is 60. My question is my CYA mixing bottle's label is a bit crooked, and so I wondered if I could just add my pool water and R-13 to a mixing vial. Then use my Speedstir to mix it, and then put it in the CYA mixing bottle to be able to pour it into the CYA tube. My problem is I'm not quite sure of the ratio of how much pool water and how much R-13 to add to the vial for the correct ratio.
If anyone could help me out, I'd appreciate it.
Today's testing results:
FC 5.5
CC 0
TA 80
PH 7.4 (it was at 7.2 after the CYA had a week to dissolve)
CYA 60 (and I still find this test difficult to read)
CH (didn't do as I have vinyl pool, but last time testing was ok)
Water temp 80
If anyone could help me out, I'd appreciate it.
Today's testing results:
FC 5.5
CC 0
TA 80
PH 7.4 (it was at 7.2 after the CYA had a week to dissolve)
CYA 60 (and I still find this test difficult to read)
CH (didn't do as I have vinyl pool, but last time testing was ok)
Water temp 80