I recently linked my Pentair EZtouch board with my mobile devices via screenlogic2. Previously, we had to operate the heater manually. It wasn't set to automatically turn on for preset heat temp, pool or spa. Now that everything is automated for remote access, I want the heater to operate remotely as well. I went to HEAT menu on EZ touch, turned "Man Heat" to OFF and was hoping when I switched over to Spa remotely,, the heater would automatically turn on. The only way it turns on is if I physically switch heater to "Spa On" via the MasterTemp control panel.
Am I set up incorrectly? When I switch spa off via screen logic, the Master Temp turns off as the valves switch back and pump turns off. (The temp on MasterTemp display spikes for a second to 126'ish then slowly goes back down. The Red Service System light stays on and this troubles me?) Should I not touch anything? Leave it in Spa On mode so when it switches to Spa it automatically turns on? Or is this bad for the equipment and I have a setting wrong?
Thanks.
Am I set up incorrectly? When I switch spa off via screen logic, the Master Temp turns off as the valves switch back and pump turns off. (The temp on MasterTemp display spikes for a second to 126'ish then slowly goes back down. The Red Service System light stays on and this troubles me?) Should I not touch anything? Leave it in Spa On mode so when it switches to Spa it automatically turns on? Or is this bad for the equipment and I have a setting wrong?
Thanks.