I just installed the IQ900-RS upgrade into my system which has the Hayward Goldline generator which was working with Aquarite status through the legacy controller. I changed the mode on the Hayward to AL-5 as described in the earlier post and recycled the controller. I am receiving a a message when I try to access the Aquapure option in settings. "AquaPure not found. Check AquaPure RS485 and power connections". I have verified the low voltage between the units is correct and the generator is currently operating in standalone mode. Is there something that needs to be tweaked in the iAqualink setup for this to detect the Hayward in AL-5 mode? I have included the specs from the systems below.
System Info - IQ900-RS
RS-8 Combo
REV T
CPU p/n: B0029221
System Info - Hayward Aquarite Goldline
T-9 Cell
r 1.58 - This is from the diagnostic panel. I assume it's the firmware rev 1.58.
Thanks for any further tips on getting this to work.
System Info - IQ900-RS
RS-8 Combo
REV T
CPU p/n: B0029221
System Info - Hayward Aquarite Goldline
T-9 Cell
r 1.58 - This is from the diagnostic panel. I assume it's the firmware rev 1.58.
Thanks for any further tips on getting this to work.