We are installing our liner now and there are wrinkles on the bottom. We have about 1/4" water in right now, so I think there is still time to fix. We tried pulling them out and tried the shop vac, but can't get them out. Any suggestions?
Did you let liner sit in sun for a bit to heat up? When I did mine I just got on hands and knees and started pushing them towards the coves. It does take time but go slow and make sure you get all before putting too much water.
- - - Updated - - -
Also the shop vac is usually done before adding water to see if Liner is good in place and while filling.
As kpromero says, the shop vac is done prior to water fill and it's sole purpose is to hold the liner tight against the pool walls so the wrinkles are gone BEFORE you put in any water.
I would get the water out of the pool and start over. If not, I think those wrinkles will haunt you from an aesthetic standpoint.
agreed with all above. It might help to use a broom and use it like a squeege to help push the wrinkles out. Some folks have had success with a toilet plunger to grab the liner and pull them out too.
Thanks, everyone! We got in on our hand and knees and pushed the wrinkles to the cove, also used the broom and in the end let the kids slide around and within 45 minutes we were wrinkle free!
Hello , This thread has been inactive for over 60 days. New postings here are unlikely to be seen or responded to by other members. For better visibility, consider Starting A New Thread.
Welcome to TFP! For a wealth of pool care information please check out our free Pool School. If you are in need of specific help then we encourage you to Register and ask us here in the forum!