Hey guys,
Like my title states, I just purchased a Polaris 360 for my pool. My pool specs are as follows:
16'x32'
Figure 8
3ft shallow end
8.5ft deep end
Approximately 20,000 gallons
Chlorine
Waterco 1HP Pump
Hayward S200 Sand Filter
My Polaris 360 works fine, except for the fact that it gets on the walls of the shallow end. When the backup valve engages, it returns back to the deep end, then it returns to the shallow end and gets stuck again. Is this normal for the 360? I have added the included restrictor, and even put in a plug on my shallow end return jet (Only two return jets), checked all hose fittings, etc., and the most RPMs I can get is 25. Any ideas, suggestions would be greatly appreciated on why it keeps getting stuck on the shallow end walls. Thanks guys!!
Like my title states, I just purchased a Polaris 360 for my pool. My pool specs are as follows:
16'x32'
Figure 8
3ft shallow end
8.5ft deep end
Approximately 20,000 gallons
Chlorine
Waterco 1HP Pump
Hayward S200 Sand Filter
My Polaris 360 works fine, except for the fact that it gets on the walls of the shallow end. When the backup valve engages, it returns back to the deep end, then it returns to the shallow end and gets stuck again. Is this normal for the 360? I have added the included restrictor, and even put in a plug on my shallow end return jet (Only two return jets), checked all hose fittings, etc., and the most RPMs I can get is 25. Any ideas, suggestions would be greatly appreciated on why it keeps getting stuck on the shallow end walls. Thanks guys!!