First...I've searched and searched. I found one thread where someone installed a second return on their Intex about a foot or two below the original return. Now I go to find it again and can't. ...arrrgg!! ....lol
Here's my delima......
My 12x42 Intex....upgraded to the sand filter pump......I think 2650 gallon. (The good one...lol)
Anyhow. ....installed the Hayward thru wall skimmer today and after running to hardware. .... I have 1/2 of the hard plumbing done.
Wanting to go ahead and install a 2nd return......probably a foot below the original return. (I'd like to install it lower....but figured there is to much pressure on the liner the lower you go.
SO.....do I need to reinforce the liner where I'm going to install the return? I was thinking of using the square piece of liner I cut out for the wall skimmer. Thiniking of gluing this prior to cutting the hole for return.
(I really do not want to plumb up and over the wall.)
?????
Here's my delima......
My 12x42 Intex....upgraded to the sand filter pump......I think 2650 gallon. (The good one...lol)
Anyhow. ....installed the Hayward thru wall skimmer today and after running to hardware. .... I have 1/2 of the hard plumbing done.
Wanting to go ahead and install a 2nd return......probably a foot below the original return. (I'd like to install it lower....but figured there is to much pressure on the liner the lower you go.
SO.....do I need to reinforce the liner where I'm going to install the return? I was thinking of using the square piece of liner I cut out for the wall skimmer. Thiniking of gluing this prior to cutting the hole for return.
(I really do not want to plumb up and over the wall.)
?????