Help, Compupool CPSC 36 control board not working

[ndenunz]

CPSC 36 unit purchased a little less than three years ago. There was no power to the board and the fuse needed to be reset. After I did that, there is power to the board but once it powers up to 10% output, it shuts off momentarily then restarts the same cycle again. Anybody experience a problem like this? Am I out of luck?






16K Vinyl in ground pool.

 

[Melt In The Sun]

sorry, don't know...did you try asking Compupool?

 

[bobodaclown]

Give Compupool a call Jason in customer service is helpful/friendly.

 

[RobbieH]

With any luck you'll get a discount on the new unit.

 

[Hal3]

Call them. They have been very helpful to me.
I was having a problem similar to that and it turned out that my connectors were corroded where they plugged into the cell.
I ordered a new set of connectors and it worked perfectly.
You could try to clean them but mine were really bad.
Or ... maybe you have a different problem.

Hal