Hey guys and gals - just ran into this nice write up I'm putting my solar in this week, but in preparation, I connected my solar sensor that just arrived to see what configuration options I have for Solar in the iAqualink. I know you mentioned that some 'new' options appeared in the GUI, but I'm not seeing much. I'm specifically looking for set temps, ect....it appears that even with solar, it's using either temp 1 or 2 (which in my case is labeled POOL and SPA). It seems like this should have it's own temp, and that it should show the temp at the solar sensor (my old suntouch controller would do that!). The manual does tend to lead to the fact that it will start at 5 degrees over air temp if the water temp is lower than the set temp - in my case it is, but the speed I programmed for solar is not kicking on. All my dip switches are in the default off position. I have enabled solar priority....just not sure why it didn't seem to kick solar on (observed by a speed reduction on my pump). Any ideas?
Thanks!
Thanks!