This past weekend I started my build on a 24' AG it all went well I got the wall up sand leveled inside and wall foam glued before running out of daylight. The next morning we got about 3+ inches of rain which needless to say filled the hole with about 4 inches of water. I pumped it out as soon as the rain stopped however the water had pushed the wall over on one side. Today it finally dried out enough to work but I discovered some nasty bends where the wall and bottom rails meet. My question is can I beat it back and install and be ok or is this going to cause problems as I fill the pool? I also have a few top rails that got bent any ideas on how to fix that?
Thanks
Sent from my iPhone using Tapatalk
Thanks
Sent from my iPhone using Tapatalk