- May 27, 2013
- 43
- Pool Size
- 12828
- Surface
- Plaster
- Chlorine
- Salt Water Generator
- SWG Type
- Jandy Aquapure 700
Greetings all!
My Jandy AquaPure is acting up. At unpredictable times, it reads "no flow." Sometimes it seems to be working just fine, others, I get that message.
The entire system is about three years old. The AquaPure 700 cell is clean. The sensor is clean, and is only about a year old. As is the wiring of the sensor back to the box.
The pool looks okay, but I'm noting the chlorine loss now. I'm not sure if it has to do with the "no flow" triggering a cutoff of chlorine production, or the fact I'm a bit low on CYA (50 ppm) and it's been hot and sunny here in South Florida for the past week or so.
Anybody have any ideas for me before I call the repair guy out for a hundred bucks an hour?
Thanks!
My Jandy AquaPure is acting up. At unpredictable times, it reads "no flow." Sometimes it seems to be working just fine, others, I get that message.
The entire system is about three years old. The AquaPure 700 cell is clean. The sensor is clean, and is only about a year old. As is the wiring of the sensor back to the box.
The pool looks okay, but I'm noting the chlorine loss now. I'm not sure if it has to do with the "no flow" triggering a cutoff of chlorine production, or the fact I'm a bit low on CYA (50 ppm) and it's been hot and sunny here in South Florida for the past week or so.
Anybody have any ideas for me before I call the repair guy out for a hundred bucks an hour?
Thanks!