I currently have a Jandy 2.5hp Stealth pump. I've always thought that it is probably oversized for my system (16k pool, equipment pad is about 15 feet from the edge, with a ~3 foot drop to the water's surface, and the total depth is 5.5 feet).
I'm considering the Jandy 2hp ePump, to get some savings. I just installed the latest iAqualink controller, so no problems integrating the new ePump.
However: I've seen a few comments where people had problems with the thread sizes between their old pump and the new one. I really really want to avoid any plumbing changes. The pool builder left very little slack between all the connections. To change the pump mounts would require a ton of re-plumbing work on my part.
How can I verify the thread sizes? I haven't found any good info yet.
Thanks, Mike
I'm considering the Jandy 2hp ePump, to get some savings. I just installed the latest iAqualink controller, so no problems integrating the new ePump.
However: I've seen a few comments where people had problems with the thread sizes between their old pump and the new one. I really really want to avoid any plumbing changes. The pool builder left very little slack between all the connections. To change the pump mounts would require a ton of re-plumbing work on my part.
How can I verify the thread sizes? I haven't found any good info yet.
Thanks, Mike