I have 2 issues with my salt system.
1. Went to 4 different pool supplies store to check my T-15 cell, all stores tested "failed". So I have to replace my cell.
2. I have a 2006 AQ-Rite with rev 1.40. With the failed T-15 cell connected, upon power up, the salt level usually displays in 4 digits (i.e.: 3200), now it reads in "x.y" format, for example, "3.2". This happened after pressing "Diagnostics" several times. How do I get the salt level display back to the normal 4-digits (xxxx)? Or is my main board defective? Or is the failed cell causing this?
I do not want to install the new cell if the main board is defective. Any ideas?
1. Went to 4 different pool supplies store to check my T-15 cell, all stores tested "failed". So I have to replace my cell.
2. I have a 2006 AQ-Rite with rev 1.40. With the failed T-15 cell connected, upon power up, the salt level usually displays in 4 digits (i.e.: 3200), now it reads in "x.y" format, for example, "3.2". This happened after pressing "Diagnostics" several times. How do I get the salt level display back to the normal 4-digits (xxxx)? Or is my main board defective? Or is the failed cell causing this?
I do not want to install the new cell if the main board is defective. Any ideas?
