- Jul 31, 2013
- 114
- Surface
- Vinyl
- Chlorine
- Salt Water Generator
- SWG Type
- Hayward Aqua Rite (T-15)
I turned my pool light on this morning and it came on, got dim, then brightened and flickered before it went out. I went to check my junction box and it had some water in it, but I never heard my GFCI outlet pop or reset. I have had this happen previously when it was full of water and drying it out worked. This time, I kinda think it may be the bulb.
my GFCI outlet sits behind the light switch that turns on my pool light. Short of putting a circuit tester on the junction box, I really don't know how else I can troubleshoot this. I did pull the pool light up to the deck and it is a Hayward (white/plastic). I';m hesitant to pull it apart as I do not have a replacement seal for it.
What should I do next to determine if its the bulb? I'm getting a new liner installed next week and want to make sure there I'm not needing anything else.
my GFCI outlet sits behind the light switch that turns on my pool light. Short of putting a circuit tester on the junction box, I really don't know how else I can troubleshoot this. I did pull the pool light up to the deck and it is a Hayward (white/plastic). I';m hesitant to pull it apart as I do not have a replacement seal for it.
What should I do next to determine if its the bulb? I'm getting a new liner installed next week and want to make sure there I'm not needing anything else.