I'm trying to hook up my heater which is the Hayward HeatPro HP21404T to be controlled by the hayward prologic (pl-p-4).
The Hayward manual... it says:
To control the board using an external switch, follow these steps :
• Turn on the heat pump.
• Set POOL mode to OFF.
• Set SPA mode to the desired temperature.
• Access the setup menu.
• Select mode E (external) on the P_S menu.
• Run two J7 (P_S) terminal wires from the HPEC-003 board to the NO
switch terminals (see FIG. 4).
• You can now control the operating mode by turning off the switch
(open = POOL, closed = SPA.)
I'm good until it says:
• Access the setup menu.
• Select mode E (external) on the P_S menu.
I don't think I am properly accessing the "Setup Menu" unless this is just the standard menu when pressing the SET button.
I can however get to the P_S menu by pressing the SET button a few times, but when in the PS menu i only have two choices... P or S... there is no E option.
Does anybody have any ideas.
The Hayward manual... it says:
To control the board using an external switch, follow these steps :
• Turn on the heat pump.
• Set POOL mode to OFF.
• Set SPA mode to the desired temperature.
• Access the setup menu.
• Select mode E (external) on the P_S menu.
• Run two J7 (P_S) terminal wires from the HPEC-003 board to the NO
switch terminals (see FIG. 4).
• You can now control the operating mode by turning off the switch
(open = POOL, closed = SPA.)
I'm good until it says:
• Access the setup menu.
• Select mode E (external) on the P_S menu.
I don't think I am properly accessing the "Setup Menu" unless this is just the standard menu when pressing the SET button.
I can however get to the P_S menu by pressing the SET button a few times, but when in the PS menu i only have two choices... P or S... there is no E option.
Does anybody have any ideas.