I'm getting close to install the wall. However, I keep reading the instructions and can't find what the white pieces of plastic are for. They are about 12 inches long and seem to go over the liner j-hook(the type of liner I have), between the top rails on either side of the uprights. Problem is they are not molded to fit curved areas.
What I am wondering is, at each pole between each wall top rail, is there anything at all that goes over the wall/liner j-hook?
Can anyone with a Matrix show me a pic of what it looks like on the inside of the pool at the posts?
Also, with a unibead liner, do you have to use the plastic liner coping over the j-hook?
One other thing. I have the Liner Armor fabric. Is it better to put the edges over the foam coves or under it?
What I am wondering is, at each pole between each wall top rail, is there anything at all that goes over the wall/liner j-hook?
Can anyone with a Matrix show me a pic of what it looks like on the inside of the pool at the posts?
Also, with a unibead liner, do you have to use the plastic liner coping over the j-hook?
One other thing. I have the Liner Armor fabric. Is it better to put the edges over the foam coves or under it?