I just had my 18x33 pool installed after filling with water on one side one (of 3) posts with "out riggers" is leaning out by about 1" at the top. it seems the out rigger settled a little (it's the last of the 3 on that side, the center post is out by about 1/2 ". I noticed my neighbors pool is like that, been that way for the 8 or 9 years they have had it. Can I straighten it without draining the water down? The pool sidewalls are level all the way around. I was wondering if I could put a steel pipe in the outrigger (it's a 2" square galvanized tube) and "Jack" it up and either put a piece of aluminum plate between the patio block they used as a base or remove the block while it's jacked up and backfill under it to raise the block to straighten it? I would do this to both the end and center one to starighten the entire side.