I have 1.5" poly lines. When I installed my Intellifo, I upgraded the pad to 2" lines. However, where the poly comes out of the ground requires an immediate 90 degree elbow. I did this with a 1.5" barb 90 degree with 1.5" spigot which then glued into the 2" bushing. I need to improve flow to the Intelliflo - I figure this 1.5" hard 90 degree elbow is probably a big bottleneck.
I'm looking for a 1.5" barb -> 2" spigot elbow OR a 1.5"Barb ->2" spigot straight piece so I can then put a 2" sweet elbow on. I can't seem to find either of these on the Internet. Anybody know where I can source one? Thanks!
I'm looking for a 1.5" barb -> 2" spigot elbow OR a 1.5"Barb ->2" spigot straight piece so I can then put a 2" sweet elbow on. I can't seem to find either of these on the Internet. Anybody know where I can source one? Thanks!